Knowledge is power, power is useful when you are stimming

Ball Crusher Electrodes

Product applicability

Product Type Ball Crusher Electrodes
SKU Codes 40089NL & 40089L

Materials And Design

These crusher electrodes are made from ABS and conductive rubber.

These are designed to apply clamping forces to the testicles while also acting as electrodes, with four contact surfaces.

The top features a red quick-release catch that, when twisted, unlocks the crushing mechanism, allowing for quick release. Familiarise yourself with its operation prior to first using this electrode.

They have a yellow wheel that can raise and lower the crush plate. The locking version has an arm that, when swung closed, can be padlocked to lock the wheel in any desired position. The quick release system will still operate when the adjusting wheel is locked..

The yellow crush plate carries two lengths of 6mm conductive rubber that can be used as electrode surfaces.

The black lower plate has two recesses for the testicles and these each have a loop of 4mm conductive rubber that can be used as electrode surfaces..

General Safety Considerations

DO NOT CONNECT ANY ELECTRICAL DEVICE TO ANY LOCATION ABOVE THE WAIST (ACROSS THE ARMS COUNTS AS ABOVE THE WAIST!), BUT ESPECIALLY DO NOT CONNECT ACROSS THE HEART (FRONT TO BACK, OR SIDE TO SIDE), CHEST, NECK OR HEAD. DO NOT USE IF FITTED WITH A PACEMAKER OR OTHER ELECTRONIC MEDICAL IMPLANT, ARE EPILEPTIC, OR ARE, OR MAYBE PREGNANT. REMEMBER YOU USE THIS DEVICE AT YOUR OWN RISK.

THIS CLAMPING ELECTRODE IS CAPABLE OF CAUSING INJURY IF NOT HANDLED CORRECTLY. CARE SHOULD BE SHOWN WHEN USING IT. FAMILIARISE YOURSELF WITH THE QUICK-RELEASE MECHANISM BEFORE USE

Instructions For Use

Fitting

You must ensure that your control box is switched off and the power level knobs are set to their minimum position before fitting electrodes! Each piece of conductive rubber is an electrode.

Each electrode has different connection options. Connect one wire from a channel to the electrode, and use a second electrode on the same channel to form a circuit.

  1. Connect one of your cable plugs to your electrode loops and the other to another loop.
  2. Apply conductive gel/lube to the underside contact surface that touches your skin.
  3. Fit the electrodes in place. Turn the yellow knob to lower the clamping plate until the desired force is obtained.
  4. Turn on your control box and adjust your controls.
  5. Enjoy and adjust the fit of your electrode during the session if required.

 Removal

  1. Ensure the output of your control box is set to zero, and ideally, switch off the control box before removing your electrodes.
  2. Unplug your cable, raise the clamping plate using the yellow wheel and remove the electrode.
  3. Wipe down the electrode to remove excess conductive gel. Clean before storing for the next session.
  4. In an eergency turn the red knob to unlock it and then raise the plate to release all clamping forces.

Cleaning

Wash the electrode in warm, soapy water and dry it before storing it until your next session. Do not use abrasive or caustic materials on the conductive rubber components.