Knowledge is power, power is useful when you are stimming

Stainless Steel Saddle Electrodes

Product applicability

Product Type Stainless Steel Monopole Electrodes
SKU Codes Saddle, SaddleXL, V2 Saddle

Materials And Design

These monopole electrodes are made from 3D-printed 316L Stainless Steel.

This process allows us to create impossible shapes using any other manufacturing technique.

Each electrode has a stretch, non-slip velcro strap to secure it.

The Saddle electrodes have multiple ways to connect to them, and they can be used as a common electrode in a tri-phase configuration, but ensure that both plugs from a channel are not plugged into the same electrode, as that can cause a short and possibly damage your e-stim control box.

General And Nipple Play Safety Considerations

DO NOT CONNECT ANY ELECTRICAL DEVICE TO ANY LOCATION ABOVE THE WAIST (ACROSS THE ARMS COUNTS AS ABOVE THE WAIST!), BUT ESPECIALLY DO NOT CONNECT ACROSS THE HEART (FRONT TO BACK, OR SIDE TO SIDE), CHEST, NECK OR HEAD. DO NOT USE IF FITTED WITH A PACEMAKER OR OTHER ELECTRONIC MEDICAL IMPLANT, ARE EPILEPTIC OR ARE OR MAYBE PREGNANT. REMEMBER YOU USE THIS DEVICE AT YOUR OWN RISK.

Instructions For Use

Fitting

You must ensure that your control box is switched off and power level knobs are set to their minimum position before fitting electrodes! The saddle electrodes are monopole electrodes, meaning you must use them with another electrode to complete a circuit.

Each saddle has four connection options. The centre area on the top side features two mushroom heads that can be connected to 3.5mm snap connectors. The front and rear regions connect to 2mm pins or 4mm plugs. Lastly, on the top side, there are loops for connecting crocodile clips.

  1. Connect one of your cables plugs to your saddle and the other to a separate electrode.
  2. Apply conductive gel/lube to the underside contact surface that touches your skin.
  3. Fit the electrodes in place. The elasticated strap can hold the saddle in place. On the regular saddle, the strap sits on top of the four metal loops, and when tightened, it deforms between them, effectively holding the strap in place. In the V2 version, the strap fits under the two arms on top of the electrode.
  4. Turn on your control box and adjust your controls.
  5. Enjoy and adjust the fit of your electrode during the session if required.

 Removal

  1. Ensure the output of your control box is set to zero, and ideally, switch off the control box before removing your electrodes.
  2. Unplug your cable, loosen your electrode strap and remove it.
  3. Wipe down the electrode to remove excess conductive gel. Clean before storing for the next session.

Cleaning

Wash the electrode in warm, soapy water and dry it before storing it until your next session. Do not use abrasive or caustic materials on the conductive rubber components.